🌡️ Inkbird ITC-100VH PID Temperature Controller with Relay: Efficient Thermostat for Precision Temperature Control Review

Works well. Displays degrees Celsius only. You need to adjust one of the parameters for the reading to be correct - have a good quality temperature sensor.

Loose solder joints? The 7-segment display for the middle horizontal segment on all four lower digits only works a few times. In other cases it is simply empty. bad skill.

Temperature controller. The wiring can be confusing but it will take some time to learn the schematic which is easy to find online. Works as expected and is used for Daily Aromatic Breath (DABS). Would recommend to any of my friends

Autotuning is worthwhile. I wish I could switch between Celsius and Fahrenheit as most of my brewing settings are in imperial units. The constant conversion required is a downside, but I should just bite the bullet and use a real measurement system.

I bought this temperature controller as an auxiliary heater for my Filastruder (3D printer filament machine) and was able to program this controller the same as the Sestos controller. Definitely recommended as a replacement for Sestos in a Filastruder or to supplement a machine with a second heating tape.

This is a fantastic device. Has a bit of a learning curve if you want to customize. I am using this for a heated build bed for my 3D printer. The dead zone was a bit small for configurable mechanical relays. It has a separate alarm relay which I use to actually shut down the entire system in the event of a thermocouple failure or too high a temperature. Full install of what I built using blueprints at: http://www.thingiverse.com/thing:1256336 Buy thermocouples that work perfectly with this…

Set up was bad for me because I have a lot of experience with electronics and weird little devices with impossible menu systems. This is the only problem you might have with the device. The relay is solid and the PID is small and unobtrusive. I strongly recommend that you insulate whatever you are heating/cooling as much as possible to use this temperature controller effectively. I currently use it to temper steel after hardening and it keeps the temperature (in a well insulated furnace) within