🔌 Inch Fuel Line Set by IZOKEE Review

This is a multi-component package offering. First, the rubber tubing is of terrible quality. I tried using it but it broke the yoke and I ended up buying a fuel line which cost me $12 at the parts store alone. Filters and clamps seem to be of almost unbearable quality. this package again. NOT RECOMMENDED.

My husband has a small motor shop and this is exactly what he was looking for. We will buy more of these for the business. It was delivered quickly and in fantastic condition. I really have no complaints, the gas hose is very thick and much better than what we bought from the locals. I recommend this to any lawnmower owner who needs a new gas hose or fuel filter.

There was hair in one of the fuel filters. Should we talk more about quality control? Filters are cheap plastic. Fuel lines are typical automotive lines of any length that you can purchase at any auto store. Also comes with the typical hose clamps which are not very tight but feel tight enough; Replace the included clamps with screw clamp hose clamps for a safer application.

Installing the fuel filter was easy as expected. No leaks were found after an initial check, but after using my UTV I could smell gas after a few minutes. I stopped and examined the filter to make sure the latches weren't tight, but found that the filter itself had a hole that allowed a fine mist to spray around the engine. I ended up throwing out both filters and buying a Kohler filter at a local hardware store.

good quality fuel hose. Very thick and strong with a metal braid and there are enough in the kit for every application. The filters aren't that great. The first lasted a while but when it came time to replace it I put the second in and when I filled up the fuel on my bike the fuel spilled everywhere. Then I noticed a crack in the plastic of the filter. Not the best quality for a part that contains something as vital and potentially dangerous as gasoline.

later The fuel line isn't 1/4 the inside diameter, it's metric and a little less. It can be made to work with a small amount of silicon. Clamps don't fit hose with 1/4" male connector - useless. Filter collapsed when fuel got on it. Stuff clogged my lawnmower's fuel pump and destroyed a $37 part. $7, a $3 sheet of gasket material and about 4 gallons of gas, and this $12 junk kit cost me over $55 and 10 hours of labor including the carburetor rebuild.

Parts are great for replacing the entire fuel line on my 20 year old garden tractor. It works great and is very easy to install. I used a little soapy water on the tube to put it on top of the filter and on top of the gas tank. Make sure the little metal spring clamps on the tube are slightly wider than the length of the ends of the filter. It makes tightening this way a lot easier and the soapy water allows for it smooth hose application.The motor started on the first try and I have mowed my…