📦 JBtek Jet Black Case: Full Access to Ports for Raspberry Pi 3 Model B & Raspberry Pi 2 Model B Review

The JBtek Raspberry Pi Case has allowed me to take my Raspberry Pi outside without worrying about damaging the Pi or the case. The JBtek case was easy to install on the Pi and after installing the four screws that came with the case the Pi was solid and secure. The case provides easy access to USB, Ethernet, Micro SD card slot, HDMI, 3.5mm jack and Micro USB power ports. The case does not allow access to the GPIO pins and other similar parts of the Raspberry Pi without disassembling and…

All these cases are about the same, so you can't go wrong. It turned out to be the cheapest back then, so they got my order. The case fits the Pi very well (Pi 2 B in my case) and is very solid with the included screws. Note that you don't actually need to add any screws as the case snaps into place fairly well on its own, but they're nice to have on a device that moves regularly. The case doesn't look very cheap as it's black so it doesn't stand out and blends in easily with the rest of the…

I love JBtek's black case for my Raspberry Pi3! This case is easy to install and doesn't look cheap. Even though it's plastic, it protects my Pi as I use it as a small travel computer/media player. Since the case covers the inside of the Raspberry Pi computer, airport security overlooked the unusual looking exposed circuit board in my travel bag. The case gives you access to all ports as well as access to the SD card. Slot. Since the Pi 3 does not have a spring-loaded SD card slot, you should…

Love this case with one small exception. I like its sleek, clean look. Exactly what I wanted for the HTPC setup and emulator where it will stand out a bit. This is not the case if you need access to some peripheral interfaces or GPIOs. Accessing the microSD is easy and sits flush with the vented side. The vented side is great and you can just watch the LEDs through it. Due to its design, the vent can be removed, which I don't need, but I appreciate the design. My only complaint is that the…

I understand why people give this device 5 stars. The Raspberry Pi B+ fits perfectly. Very often this type of low cost "project box" case is manufactured to poor quality tolerances. I get annoyed with things like connectors and seams that don't line up perfectly. With JBtek, the USB and Ethernet ports are absolutely flush with the back of the case. The audio/composite video jack is perfectly centered in the case's opening, and while the HDMI port is slightly offset to the side, it's still…

This is a regular case for Raspberry Pi but it has a major design flaw. Worse, the Revain list lies about the case in a way that makes a mistake worse. On the other hand, this is a stylish and sleek Raspberry Pi case. The Pi slides in easily and fits perfectly. The rounded edges, recessed connector area, and the way the SD card sits flush with the surface make this a good case for people who need to toss their Pi in a bag or some other place where he can get caught in a case with a large number

As with some others, I had a bit of an issue with the screw holes themselves being slightly trimmed (not the screws). I find the plastic too soft. However, he holds up very well between all four. Somehow I only had three screws (but one of them must have fallen out when unpacking). I keep some screws in Spam cans and found one that fits very well so they're a pretty standard size. would say. I also want the back where the memory card goes in not to be totally loose. It should probably be either