JCP Heat-Resistant Header And Exhaust Pipe-Wraps (Tan Fiberglass (Heat Treated) Review

great product works great at lower tailpipe temperatures. I have used it on my 2 cylinder Honda alternator and to repair the stainless exhaust system on my 2002 Chevy van. It also helped fix the exhaust leak I had on the van. Good product

I wrapped them around my short tubes on my Harley. Looks great, dries well. I don't know if it was the manufacturer or my experience, but when I finished this time I didn't have that itch. The bike is still being repaired so I don't yet know how they will react to the heat. I'll update if it's not perfect.

Easy to cut with large scissors. Provides heat from the catalytic converter where the tailpipes exit the exhaust manifold next to the cylinder block and oil pan. Used JB Weld high temperature paste and stainless steel clamps to install in place. The past prevents the winding from shifting along the outer diameter of the two round coils.

I have this on my exhaust manifolds, top pipe (Y-pipe), down pipe (4"), CAC pipe(s) and wiring (new, join no I would say don't take a tool to tighten the tape, useless and even counter-intuitive honesty. Alternative lifestyle pliers (ladies, as my dad called them) are perfect for wrapping and cutting in one go, people said , I was supposed to use water, I didn't feel the need.Latex gloves and a tight set of overalls or paint suits will be the last step to keep the air hose away from you.Smoke…

Great product that does a great job of reducing tailpipe temperatures. I have used it on my 2 cylinder Honda alternator and to repair the stainless exhaust system on my 2002 Chevy van. It also helped fix the exhaust leak I had on the van. Good product

I wrapped them around my short hoses on my Harley. Looks great, dries well. I don't know if it was the manufacturer or my experience, but when I finished this time I didn't have that itch. The bike is still being repaired so I don't yet know how they will react to the heat. I'll update if it's not perfect.

Easy to cut with big scissors. Provides heat from the catalytic converter where the tailpipes exit the exhaust manifold next to the cylinder block and oil pan. Used JB Weld high temperature paste and stainless steel clamps to install in place. The past prevents the winding from shifting along the outer diameter of the two round coils.

I installed this on my exhaust manifolds, top pipe (Y-pipe), down pipe (4"), CAC pipe(s) and wiring (new, no splicing required). .I'd say don't take a tool to tighten the tape, useless and even counterintuitive honesty.An alternative lifestyle pair of pliers (ladies, as my dad called them) is perfect for one-shot wrapping and cutting.People said I... was supposed to use water i didn't feel the need.latex gloves and a solid set of overalls or paint suits will be the final step in keeping the air