💡 T8 U Clips Holder Bracket for 8FT LED Light Bulbs - 40-Pack Stainless Steel Mounting Accessories by JESLED: Prevent Sagging and Securely Replace Fluorescent Tubes with Lamp Support Review

These clamps hold the pipe fairly well without scratching or being too far from the brackets. The tube only needs to be bent 1/8" (tube has over 8 feet of free play) to fully enter the clamp, and the plastic rubber grips prevent the tube from twisting or snapping while the trains are moving. to get your own screws as they come without them.

I bought these clamps for my LED tubes (https://amzn.to/2FMxJbQ) because they are 8 feet long and a lot of reviewers said they sagged. These clamps are perfect for the job. They slide over the bulb (see my picture). I screwed them into the sheet metal with a small 3/8" self-tapping metal screw. no looseness!

These clips could use some improvement, they seem to break easily but the best part is that I wrote a review and gave it 2 stars and the company emailed me straight away Mail sent and my money refunded. It was totally unexpected and frankly amazing of them. I have also bought tombstones from them and they are great. The clips just need a bit of work. I only gave five stars because they responded to my problem so coolly. There + on duty.

Arrived on time as expected. I installed them today on pipes that were installed last week. Installed pipe has approximately 1 inch (8 feet) of play at the center of the pipe. The clamps were easy to install and now they don't sag anymore. Also, I find them much safer. I was concerned about the possibility of them falling off as the sagging increases. I recommend them for at least 8 foot pipes.

Ordered a box of 12 to retrofit existing fixtures in a work area with 12 foot ceilings. Bought these for higher lumens and not disappointed. Installation is much easier and cheaper than replacing the entire fixture. Simply remove the old ballast, strip the ends of the wires and attach the 120 volt wires to one side of the light and the neutral wire to the other. They are brighter than my old fluorescent lights which is what I wanted. Check YouTube if you have any installation questions.

I bought these to keep my 8" LED bulbs from sagging in the middle. Good quality brackets at a good price. I was surprised how small they are but don't worry they slide apart easily to fit. The ends have a rubber coating to hold the bulbs. They don't come with screws. One star deducted because they are a bit short. The ends of the tombstones hold the bulbs a little farther from the base than the clips allow. I've uploaded pictures to show you what I mean. It's ok, the clips hold the bulbs by the

12 pack Arrived earlier than expected. They were easy to install. Remove your existing bulbs, cut the wires from the ballast, remove the ballast wire from one end of the tombstones to the same end of the ballast wires, connect the other end of the tombstones to the other end of the ballast wires, lay down Put it back together and never worry about your lights working in high humidity or rain. Bright cool white light so refreshing without the constant buzz. The JESLED lamps are just great, I…

. Installation is easy, although you'll need to take a few precautions to avoid getting metal shavings in your eyes when drilling the hole required for each clip to attach with the one screw you find on the need to attach metal. body of your existing ceiling lights. A clamp near the center of the 8ft lamp tube is sufficient to support the fragile 8ft LED lamp tube, which tends to sag along its entire length. For assembly, I first partially assembled the clamp on the LED tube. After installing…

These lights are more than impressive. I've been using 8ft heavy duty lamps in my buildings for almost 20 years and the electric bills have been amazing. I've gone with LEDs and removed the energy-intensive ballast that heats up, and this is where you can put all your might. These bulbs are unballasted and fit my old retro style fixtures and produce no heat. In my opinion it's a win-win situation and having reduced my electric bill in just a month I couldn't be happier. We turn on the light in…