🏍️ Kinstecks Motorcycle Indicators: Flowing Turn Signal Lights for Enhanced Motorbike Safety - 4PCS, 12V, 12 LEDs Review

They have a neat pattern which I hoped would draw attention but they only really show up at night. I'm glad I read the other reviews about not over tightening them as I can see them breaking. But don't expect high quality for the price.

Replaced the ugly regular turn signals on my bike. They appear brighter, appear cool even and are thinner. The four pack is pretty cheap and the build quality seems to be good. I had to cut and solder the wires but if they work with your existing taillights it should be plug and play. For the price I can't complain.

Over tightening will pull the screw out of the actual bracket. Once installed, there is no way to keep them taut. I've tried Loctite, glue, etc. They unscrew from the case and don't stay in place. Save your money and buy something more expensive but better assembled. If you need to put them on to pass a test, then they're fine for that purpose, but not for actual long-term use.

Received my sequential turn signals today. Installed them on my Beta 500 RS and they work great. They look fantastic and are exceptionally bright. Installation was very easy. Had to upgrade my bike to LED turn signals but that was to be expected. Will definitely be buying for future cars and definitely recommending to friends and family looking to upgrade their turn signals.

I will say in all honesty that I bought these in the hope that I would return them, unhappy with the brightness. I was wrong, actually. I am very happy with how bright they are, they are visible in daylight, the scrolling effect looks cool (see attached videos) and they are pretty easy and safe to install. Use some blue Loctite to install them securely without over-tightening and peace of mind.

They seemed good when they arrived but after 1 week there are already signs of water getting in, the other glue they used for the Use assembly just can't stand it and it hangs. At one point there was a strange bug in a signal during firmware. Just spend a little more and buy something else. I would have sent them back but I have to wait for a replacement before I can take them off. Completely dissatisfied with my decision and the build quality of these lights.

Large factory turn signals replaced with these smaller turn signals. Looks nice! More than bright enough and with a gentle flash. They draw more attention to the signals. Has 600 HARD miles on them (SuperMoto) and works great. I like that they are flexible but not too flexible. Installation was easy, I cut off the factory connectors and soldered them to these new turn signals! Looks like they came from the factory on Dizzer. They need an LED turn signal for them to work properly on a bike like…

Nothing special about these turn signals. The brightness is about what you would expect for the price. They're definitely hard to see when the sun is out, but they work well at night. They love to fall apart easily. I have followed other reviews' advice and not overtightened them as this would damage the unit which would cause them to migrate after long freeway trips. The O-ring helped fix that. My biggest problem was that 2 out of 4 modules fell off the base and got stuck from time to time…

I ordered two (out of four) of these bulbs to replace the original bulbs on my 2008 Buell Ulysses. The brackets on the two front blocks were worn and broke despite my attempts to repair them. I bought eight because the back two are running out of time and I needed parts when the new ones broke down. They work fine. When activated they have a nice "smooth" backlight, then stay constant until they turn off, then the cycle repeats. They have almost the same brightness as incandescent bulbs and are