🚽 Kohler Genuine Part 1083980: 3" Toilet Canister Flush Valve Kit - Reliable and Durable for Efficient Flushing Review

If you're buying this, you're probably buying it because the rubber seal on the pipe that raises and flushes the toilet is worn out. If you twist it a little, it will burst. Then you only have to replace it with a new pipe, not the entire assembly. There should be nothing wrong with the original flange in the tank.

K-4634 Kohler Cimarron is commonly sold at Lowes and Home Depot so causes misinformation like that in the lead review regret . So a picture says 1000 words. 1083980 works with both 1.28 and 1.6 GPF versions of K-4634, you just need to adjust the level in the tank (on the float valve - the other part) according to the amount of water you want to flush!

This part does not support the same inlet hose and these hoses are not easy to replace. Basically I have to glue the hose as a last resort while trying to find a replacement part that fits. The part pictured in this Revain product listing is the correct part where you will insert the tubing into the receiver. The device I received requires a softer/more flexible tube to fit over the nipple. The hose from my inflation valve is made of hard plastic and just doesn't fit over it.

First of all I hate these things. I have 6 toilets in my house, all have this type of toilet valve kit, all need to have their seals replaced at least once a year, they all work erratically, they are all fragile and I have had to buy several of these kits. substitute. I think they are bad design. Okay, if I don't replace the toilet I'll be stuck on these valve sets. They work just like the originals. Be sure to buy the right size.

Overview of toilet parts. Never expected it! I'm taking my time getting this done as the product arrived on time and being an OEM part it worked great. The instructions were actually in English, not just pictographs. Instead I have ordered other items listed as suitable for this type of toilet but they have failed miserably. Technical Advice. Don't do a real test until you're sure it works, the 'fake' part didn't work. Pooh. Now I am a firm believer in buying the exact part from the…

The Kohler toilet has detected a leak between the upper tank and the bowl. The flush valve has 3 seals. One gasket (mine was yellow) is used inside the flush valve and prevents water from the tank getting into the toilet (replace this gasket if the toilet runs all the time), the second gasket is under the flush valve (mine is red) . ) and seals the inside of the flush valve box. If this seal fails, water will seep between the upper tank and the bowl. The third gasket (mine is gray) is placed…

Easy to install if you have a 6 inch wrench. The instructions don't state that the ring that secures the valve in the reservoir from the outside is about 6 inches. in diameter and you need a strap wrench to tighten, I mean tighten. I don't have that big strap wrench, I'm a mechanic, not a plumber. However, I have installed hundreds of Chrysler fuel pumps of the same design. Take a flathead screwdriver and a small hammer and, holding the screwdriver right on the edge of the plastic retaining…

I found it very easy to fix my Kohler toilet with this kit. I'm not mechanical at all, and when I started noticing signs that my toilet wasn't sounding right, I did nothing but hope that somehow it would fix itself. Yes, I was seriously in denial. In the end it just didn't work anymore. I went online and entered dysfunctional characters. Voila! All kinds of self-help advice and demonstrations were offered. As a result, I ordered a complete canister valve kit. Removing and replacing the old…