🚿 Enhance Your Shower Experience with the KOHLER K-1046987-CP Shower Faucet Handle Kit, Small Review

I used this to replace an old Kohler grip. The screw cover on the old handle was broken as shown in the attached picture. A great replacement for this type of pen.

Perfect replacement for my old pen. It took me 5 minutes to install. Make sure you have an allen wrench to tighten it! PS Stay away from generic faucet replacements. The handle broke after 3 uses.

The little black plastic sleeve that Kohler used to attach the grip was probably poorly designed from the start. But if the bushing is broken or worn out, this will fix it.

I broke a small piece of black plastic on my old shower handle when we were replacing a worn hot water valve behind the handle. We looked for this part in 3 hardware stores, but to no avail. It fits perfectly.

Lever good. However, I found that once installed, this assembly failed to properly clamp the water control valve. For example, I couldn't take a shower after 2-3 uses and had to remove the lever and tighten the cuboid part again. The end result is poor engineering and better design is required.

Nice pen. Pretty hard. However, it didn't fit our shower stall which used to have a handle. I have attached an image for reference. The handle just isn't deep enough to accommodate the long post that the handle is attached to. We bought another pen from Revain and it fits perfectly. Lever handle Kohler 71904-CP. https://www.amazon.com/dp/B002C5ICP6?ref=ppx_pop_mob_ap_share