🔩 KREG SDK C2SS 700: 2 Inch Coarse Stainless Steel Screws for Ultimate Strength and Durability Review

Really nicely made precise screws, I haven't had any issues with the cam or the snap but I'm used to working with stainless fasteners and I know they are soft , and I use a clutch and I'm sure to sink well. I wish there was a longer version because where I live we only have very soft, fast growing log pines and the length isn't long enough to make a good purchase.

Unusable. These screws were backed out, removing the head of every fourth screw, even with pre-drilling. Then some morning dew and my wooden floorboards are oxidized! My butt is made of stainless steel. Waste of money, I'll be back. I had to attach the first edge of the decking board with end screws, but I did the same to the edge of the screwed board. So angry. The Kreg Jig is useless now that it uses these patented screws and bits. Get a camouflage system, don't bother with it.

It is best to use a cordless torque wrench so that you don't cut your heads off with these screws. A pilot hole is required. Set a low torque when screwing. Too bad I didn't dip every screw in dish soap as a lubricant. This would prevent multiple screw heads from being stripped. These screws use a patented Kreg screwdriver. It's a square bit but with curved sides like a torx bit. The Kreg Chisel is only available in one length, 6 inches long. For narrow gaps, a regular #1 square cutter can be…