🚀 Enhance Suspension Performance with KYB SB102 Strut Boot Review

Definitely a good option when replacing struts. The fender/bellows/cylinder interface is different from the OEM configuration and how they come together can be confusing for some people, but if you look at the instructions and place the fender on top with the bellows in the channel it all fits together perfectly . Time will tell how they hold up but so far I've had good results with KYB parts.

Dear friends, I purchased this item to complement the shock absorber/strut replacement on my 2008 ES350. The problem is that the Lexus Gator is built into the upper rubber spring damper, I had to cut off the damaged part of the Gator, screw that piece in and reuse the upper damper. In short, I think it kind of fits, but it's not a replacement. It's hard to understand when your car is on a jack and the stand is off and on the ground. JS

I purchased these fenders for a 2011 Acura MDX front suspension overhaul. Fender as I fitted great and met my expectations without fail. However, the plastic accordion bumper did not fit the MDX, although the installation instructions said it would fit directly. The factory MDX parts were still in great condition after cleaning, so it didn't really matter. First of all, I ordered this kit for the fenders themselves. This is just a warning to those ordering them for mdx 2011.

So this worked fine and installed on my KYB Excel-G gas springs which I just installed on my Camry. The only reason I know this is the way to go - despite their written instructions and the videos they provide - was by searching for images on google. face palm. All they had to do was 1 photo of it mounted on a stand and everyone would understand but no. Instead they showed you how to remove/reinstall the brace but never how to install the brace. So here it is. On the Toyota Camry, the white…

They will NOT fit the C-pillars of the 2.5 liter Subaru Legacy 97 station wagon. You are too short. front racks, but I did the rear ones and they are too short. I had to be tricky to get them working. Cut off the top flat portion of the old bellows and slide the old bellows over the bottom of the new bellows to make one large bellows. .actually it worked very well and fully covers what needs to be covered. Of course, you should wash the old bellows thoroughly and examine them for holes or…

Fits Toyota Corolla 2009 but no more. At the very top of the spring is a rubber support for the spool to keep it from moving and wearing out in the mount. Until I disassembled it, I had no idea. I had to reinstall this spring and strut with some creativity because I don't have spring compressors it was a pain but I did it and used this product because I wouldn't go through that again especially when I need my car. nothing but cheap plastic so you get what you pay for. I've found that many of…

I bought two of these to replace the original bellows (or boots) on my 2002 Toyota Camry LE V6 with 100,000 miles along with factory replacement ( OEM) with KYB GR-2 Racks (334338 and 334339). The KYB design here differs slightly from the OEM used on the Toyota Camry. This KYB product consists of a baffle (foam that sits around the piston to prevent it from sinking completely) and a bellows (accordion-shaped tube that keeps dirt and dust out of the piston rod/shaft). One piece with an upper…