💡 Enhanced LG Electronics 5301DD1001G 6026050 Dishwasher Heating Element for Optimal Performance Review

Correct part but the gasket didn't fit properly and was leaking through the center hole where the sensor is. Set it to 2.5 lbs for proper tightening (according to the manufacturer). SOLUTION: I ordered a food grade sealant (DAP 00688 General Purpose Adhesive Sealant, 100% Silicone, 2.8 oz) and sealed it around the sensor and outer rim during installation. .One month later the seal is still holding, the heating element is doing its job 👍

The first one I received didn't fit properly so they sent me a replacement. I was still having trouble fitting it and not leaking it, but after some back and forth and a few hours later I finally managed to fit it without leaking. I will say that I have repaired several appliances and nothing has tested my patience more than trying to get it to work on my lds5540st dishwasher. All in all it took away my "er" error code, it was cheaper than other parts sites and I still had half my sanity left.

I bought two of these items. When I took my old one out I checked it and saw zero continuity (so I knew it had been taken off). The first went in with no problems and worked. For two cycles. At this point I started troubleshooting other parts of the washing machine that might be causing the problem and eventually found that the 'new' hearing element was also damaged so I ordered a new one. I wanted to return the old one, but too much time has passed. When I got the new one I checked for…

Do not buy this dishwasher. It cleans decently but has failed several times in less than two years. Update: If you get an HE error, take out your dishwasher and check the left side where there are some pipes. There is a transparent box with two floats, there are electrical wires connected to switches that can be activated by the floats. The problem is that dirt collects on the floats and in the transparent box that contains the floats. If the floats aren't working, the water in the tub won't…

The dishes were not dried and the dishwasher began to smell musty. I checked the current draw during the drying cycle on my circuit board and less than 1 amp indicated the heating element was bad. Replaced a heating element purchased through Revain. Part arrived very quickly. The repair wasn't difficult after the dishwasher was taken out of the cabinet and tipped on its side. Installing the part was very easy, just be sure to loosen the set screw all the way to release the rubber grommet that…