Header banner
Revain logoHome Page
πŸ”’ lisle 28000 ratcheting lock nut tool: unlocking superior precision and efficiency logo

πŸ”’ Lisle 28000 Ratcheting Lock Nut Tool: Unlocking Superior Precision and Efficiency Review

4

Β·

Very good

Revainrating 5 out of 5Β Β 
RatingΒ 
4.8
πŸ› οΈ Tool Sets, πŸ”§ Automotive Tools & Equipment

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ”’ Lisle 28000 Ratcheting Lock Nut Tool: Unlocking Superior Precision and Efficiency

Details

Fastener TypeLock
ColorFactory
Drive SystemSquare
BrandLisle
Item Dimensions LxWxH5.8 x 5.4 x 2.9 inches

Description of πŸ”’ Lisle 28000 Ratcheting Lock Nut Tool: Unlocking Superior Precision and Efficiency

Double-ended for both sizes of ratcheting style lock nuts. Comes in clam shell package. Large end fits 1985 and newer Ford F150 - F350 trucks with the Dana 80 full floating rear axle. Use with 1/2" square drive. Comes in the clam shell package.

Reviews

Global ratings 4
  • 5
    3
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

1/2 " reversible drivetrain bearing locknut tool.

Suitable tool for removing and preloading bearings on Dana 60-80 and Sterling 10.25 and 10.5 differentials (fully floating). , formerly made in America, now in Taiwan.

Pros
  • Supplied in a snap-on pack
Cons
  • No instructions

Revainrating 5 out of 5

Runs at 10.5 Sterling on a 99 Ford F250.

Item as stated. I just replaced the rear axle oil seal on a '99 Ford f250 4x4 double cab axle. Remember to tighten 6 clicks then loosen if reusing used bearings. I only heard the click when you stepped back.

Pros
  • Use with 1/2 inch square drive
Cons
  • No power

Revainrating 5 out of 5

Well built, durable tool

Two shafts on my old hub locknut remover from a cheap parts store broke in the middle of replacing the rear brake disc / Double pads on rear Ford dana80. None of the local parts stores had these tools, Revain to the rescue. After paying a few dollars for shipping one day, it was at my door the next day - days before it could be picked up at any of the stores. This tool is much stronger for about the same price.

Pros
  • Large end fits 1985 and newer Ford F150 - F350 trucks with fully floating rear axle Dana 80
Cons
  • Empty

Revainrating 5 out of 5

Fits on more axles than specified!

I needed a special tool for a ratchet locknut on a 2006 Ford E-350 Cutaway, Dana 70 fully floating axle. The service manual lists Ford tool number 205-282 (T88T-4252A-A). Ford tools cost 4-5 times more on other sites. The best price I found on an aftermarket tool before ordering was more than double the price plus shipping. Since no one could tell from the description that this would fit the car I was working on, I contacted Liesl. They confirmed it would work so I ordered it. This tool worked…

Pros
  • Reversible for both sizes of ratchet locknuts
Cons
  • Secret