Header banner
Revain logoHome Page
lmt onsrud 57 240 uncoated diameter logo

LMT Onsrud 57 240 Uncoated Diameter Review

1

·

Excellent

Revainrating 5 out of 5  
Rating 
5.0
🪚 Router Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to LMT Onsrud 57 240 Uncoated Diameter
img 2 attached to LMT Onsrud 57 240 Uncoated Diameter
img 3 attached to LMT Onsrud 57 240 Uncoated Diameter
img 4 attached to LMT Onsrud 57 240 Uncoated Diameter

Description of LMT Onsrud 57 240 Uncoated Diameter

Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but are more brittle and must be used with rigid toolholding systems. Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications. Round shanks allow use with a wide variety of toolholding systems. When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging. Double flute, 30 degree angle.

Reviews

Global ratings 1
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

That shot was amazing. If you use it correctly, you have .

This nozzle is amazing. If you use it correctly you will have BEAUTIFUL cuts. If you cut too slowly, EVERY bit will overheat, char, dull, and/or break. Touch the attachment once you've finished slicing (and the machine is safely off) and it should be at room temperature or slightly warmer. If it's hot, you're doing it very wrong. When cutting, you should discard CHIPS, not sawdust. Chips remove heat from the drill. I've cut at 324 ipm and had great cuts from 57-260 to 3/4" MDO (MDF veneer on…

Pros
  • Double Flute, 30 Degree Angle
Cons
  • Small Parts