🔦 MAG MATE WTHM01: The Ultimate Magnetic Torch Holder for Convenient Lighting Review

Magnet is not strong enough for the weight and torque of an industrial lamp, but may fit a small hobby lamp. It can be screwed to the table from above, but it is easier and cheaper to weld a small piece of square tubing to the table. It came with a piece of foam that would be good not to scratch the surface you are attaching it to. At the same time, foam rubber also reduces the effectiveness of an already weak magnet.

I'm tired of putting down the torch and accidentally unscrewing a few centimeters - a few meters of wire when you inevitably pull the trigger. It's great for me when I'm doing structural bodywork. The magnet is strong (stays in place at a 90* angle, with the entire length of the spray cable weighing it down) but is still easy to remove and reposition when working on/around the vehicle. Good design and the weld points that hold it together are of good quality if a bit long (just need to clean or

I bought this because I didn't want to waste time building it myself and the price was right. It is very well built and looks very nice. The problem is the magnet which is quite large but not strong enough to hold the flashlight on my Hobart 210 (not a big car). Using the flashlight carefully will usually stick it to the table, but using it too quickly, dropping it, or hitting the wire while it's in the holster will make it fall off the table. My table top is 1/4 inch thick steel and I think it