MuHize Mini Fuse Tap: 12V Blade Fuse Holder & Add-a-Circuit Adapter with 15 Amp Mini ATM APM Blade Fuse (5 Pack) Review

There was a problem installing the fuses in the slots. When installing fuses, be careful not to damage the faucet. Otherwise they work well and stay in place.

Fuses do not fit. I used it as a jumper to power a fuse circuit that had no power. I had to hammer the OEM conical fuses into the holders with a small hammer to get them in the right position. The supplied fuses were blunt and wouldn't go into the holder even with a hammer.

These things are amazing. Installed a stereo on my Harley and was able to light up the fuses on my accessories. The radio turns on when I turn the key so I don't have to worry about leaving it on and draining the battery. Then I'll try them on the lightbar that's on my truck. Adding accessories is so easy!

I needed to add another permanent circuit to my 2009 Subaru Outback for the lightbar I had fitted to the rear of the car. This Add-a-Circuit Fuse Tap hit the spot. Works great, took about 5 minutes to install. I wish I had known these things years ago! I've found it took some effort and trouble to get the fuses in properly, but they seem to work fine in the end.

Can't complain about the price but be careful installing the taps in the fuse box as the blades can be easily bent; It's not the thickest or best material. I ended up bending one since my fuse box is deep in the glove box and I pushed it through remotely with needle nose pliers. Also, they have been powering my DVR for the past 5 months with no issues. .

You add a chain, what do you expect? The fuses are VERY tight but will fit if you have trouble. Get stronger. I am using 3 of these in a turn signal mod that I need to connect to the BCM trailer wiring. The fuses are right next to each other which caused an issue with the way the wires come out the side (can't find any that come out straight) so I had to mod them to make them work but if you mod, you have to change things to mod lol

I Purchased: Mini-Fuse Blade Holder - Muhize Fuse Tap 12V TAP Automotive Fuse with 15A Mini ATM APM Fuse (Pack of 5) Faucet WILL NOT fit the outlet in the 2011 Honda Pilot fuse box. They are too thick and don't taper properly. If you have a Dremel you can gently sand the ridges, starting gradually at the top about halfway down. Keep rubbing until you get a firm fit. After that, you have to face the fact that the faucet itself will not accept the supplied fuses. Or the fuses that come with the…

Vehicle: 2005 Subaru Outback Limited (H4 Automatic) Note: They come with 15A fuses I have a USB powered DVR 2.0 installed which does not once the full 1A was enough, so I changed the mini fuses to 5A. I don't think Muhiz offers that combination. However, 5A fuses are cheap. This is mainly to protect the long DVR power cord which can probably draw 15 amps, but I saw no reason to risk that. The taps fit very well in the fuse box, even the fuses on the taps fit over the adjacent mini fuses. They…