Monoprice Fireplace Pull Down Full Motion Articulating Review

Should have spent a little more money and bought the mount he copied. This will prevent you from adjusting to off-center wall studs. The "adjustment" available also causes the TV to hang unevenly, as the weight of the TV is not centered in this case and the entire arm assembly is twisted. The hydraulic adjustment of the lever does not work either. You can go all the way from one extreme to the other and the TV is still very difficult to raise or lower. I feel like I'm about to rip everything…

I bought a 40-63" model for my 46" TV, about 4.25" above an 8" deep panel. The installation steps make sense: install wall mounts, install TV mount hardware, then fasten and secure. The included screws, bits etc are plentiful and well organized to suit different VESA sizes. Two people are perfect for assembly and perhaps a step stool would help. The included guides for articulating air pressure and cover placement were helpful, although a magnifying glass or digital zoom could have helped…

That would be a great price EXCEPT. Assembly requires your cabinet to be exactly symmetrical about the center of the chimney. I have a bobby pin right in the middle and then another 16 inches on each side. This mount requires each stud to be exactly 8" off center as they must be inserted into the studs and there is no adjustment for the mount's screws/bolts. be off-center. Most mounts give you multiple screw holes and still allow you to center your TV. It's not like this. Unfortunately I'll be…

I bought a very large TV and following your instructions I thought this would be the best and smartest mount. I was so happy to receive it. That feeling lasted until the installers tried to install it. You, 2 experienced installers, worked on it for over 6 hours. I know it sounds unrealistic, but I was there. Tried everything but the stripes are too short to stay in the middle. When touched it becomes erratic, swaying like an open walkway, and most annoyingly, it doesn't stay on an incline and…

I bought mine direct from Monoprice. This mount gets the job done for a reasonable price. You should be comfortable mounting it yourself as the instructions are in 2 font size and DO NOT specify exactly the correct mounting height to allow the bracket and TV to clear the space. mantel when fully lowered. I have a 7 3/4" mantel and the instructions say I can only install it 5" higher. NOT CORRECT. Revain has an identical mount that is repackaged and sold under a different brand (Aeon-50300)…

This is a great mount that serves its intended purpose. A few things to note: you'll need to adjust the compression spring to accommodate the weight of your TV, as people have said. There's actually a little chart in the strut behind the spring that shows the weight. Here's how to adjust the spring for the weight of your TV. I only pre-adjusted before installation and did not have to adjust again after installation. The table is small, but it's there. Also, this mount will work with studs that…