Header banner
Revain logoHome Page
moog 521000 hub repair kit logo

MOOG 521000 Hub Repair Kit Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🦾 Bearings & Seals, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to MOOG 521000 Hub Repair Kit
img 2 attached to MOOG 521000 Hub Repair Kit
img 3 attached to MOOG 521000 Hub Repair Kit
img 4 attached to MOOG 521000 Hub Repair Kit

Description of MOOG 521000 Hub Repair Kit

EXTENDED SERVICE LIFE -- Application-specific advanced raceway design reduces stress, rotation and heat on components. EASY TO INSTALL -- Engineered and designed for fast, hassle-free installation. CORROSION PROTECTION -- Coated wheel studs resist corrosion and rust for easier removal and proper torqueing. RIGOROUS TESTING -- Comprehensive testing throughout design and development processes by MOOG engineers for quality you can count on.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Moog Hub but National Bearing.

Well assembled products but the bushing is made by Moog and the bearing is made by National. Both are good brands but they don't state this anywhere in the description. They only get 3 stars for that.

Pros
  • Free for educational use
Cons
  • Contact Seller

Revainrating 5 out of 5

Probably better than factory.

The factory tire failed at 220,000 miles, there was a hesitation that looked like a wheel was about to come off. The case inside was very painful to pull off - I have a 20 ton magazine press that couldn't get it out. They took it to the shop for pressing, they had a 100 ton hydraulic shop press but they didn't want to go over 20 lest they bend the joint. Instead, they cut out the liner on a grinder. The new part fit with no problems.

Pros
  • Absolutely amazing!
Cons
  • Not bad, but...

Revainrating 5 out of 5

Planned to need a mechanical shop to press and reseat, remove the hub and then the brake parts.

2003 Explorer XLT has been damaged. It is planned that a mechanical workshop will be needed to press them out and put them back in place. and airguns (Nitrocat 1200k and IR TI2135) would not remove these bearings, nor would my 12 ton press. I've bent OTC bars with pneumatic wrenches. hub installed. A set of hub and bearings Moog (Korean bearing) of high quality, there are no installation problems.

Pros
  • Hard Finish