Ultimate Precision: MOOG K80276 Caster/Camber Adjusting Kit Unveiled! Review

When installing these camber bolts, be sure the center washers are perfectly seated on the guides, otherwise you will turn the bolt in the washer and destroy the center point. Trust me I found it the hard way and had to order a new one. Another tip: Sanding the spot and applying anti-seize paste supports the middle movement when adjusting the camber/lag.

I bought these for my 2006 Nissan Titan as the 06 factory stopped fitting them on trucks. I added a front end alignment kit and a new Bilstein 5100 that had to be retired for positive camber. I also added after the highlighted top controls. Installing it helped restore correct camber and probably roll when aligned. So far they have no complaints.

They work I had trouble getting the old ones out and ended up cutting out my Nissan Frontier's lower A-arms and replacing them with new ones. Therefore, after cutting out the lower wishbones, they were easy to assemble. If you have a new model, you can probably close it right away and put the new ones in. Be prepared to spend some time with your Nissan if you can't get your hands on the old ones.

You will first need two sets of these parts to build a truck. (one for the left side, one for the right side). If you are in the process of removing the old lower A-arm bolts, you may find that one or more cannot be removed without cutting them off. and then you need to replace the gasket in the A-arm. (The screw gets stuck in the spacer in the rubber mount). Once everything is removed and replaced these camber bolts are easy to install and allow for camber adjustment.

These adjustable camber bolts were used on my 2015 Frontier 4x4. They are longer than the original screws but do not affect performance in any way. I would suggest getting a 22mm socket or wrench to tighten them. I installed mine the night before I drove the truck for wheel alignment. The tech adjusted them and was able to get the camber to dealer specs. Each set contains 2 screws. You will need 2 sets, one for each lower control arm (driver and passenger).