🔍 Enhanced SEO: MOOG RK621294 Control Arm and Ball Joint Assembly Review

The left and right lower control arms were replaced and the parts made a good first impression. But now, less than a year later, all bushings are broken. I do not recommend this part.

The bushings on them are completely removed in less than 3000 miles. It's so bad that my tires wear out unevenly and I can't drive on the highway. They weren't very suitable to start with either, in any case very cheaply made. The original Toyota bushings lasted almost 200,000 miles. It's garbage.

High-quality assembled lever set with new bushings and new ball joint! screws in place. I replaced both lower arms and installed the 2.5 riser kit on my 2006 Tacoma with 120,000 miles in 5 hours. Good smooth ride, now very smooth over bumps, no more rattling when hitting big bumps.

at the end of May and they are completely broken, they disconnected the LCA guides on the hub, this happened after about 2 weeks of not installing could. I couldn't figure out where this noise was coming from so I started swapping parts out until I put the camera under the truck while driving. These bushings are known to be loose on the forums. So be careful. I wouldn't buy them again. bought them because I needed to get back on the road. There is definitely a manufacturing issue with them, not