🚀 MooSun 4" Performance Cold Air Intake Kit with Filter for GMC Chevy Chevrolet 1999-2006 V8 4.8L/5.3L/6.0L: Improved Airflow for Enhanced Performance Review

Cool box Tolerances could be more precise. There is a little "assembly" during the installation. All in all everything works well and sounds very nice.

You can really tell it's low quality. Had to haggle a bit to get it. The air filter is very tight. It would be better if the air filter was a few inches shorter. but it worked for a 15-year-old Yukon.

The intake kit was good except the rubber boot used to attach the MAF sensor to the pipe was too big. I could stick my finger between the maf and the rubber boot. I had to make another shoe. Otherwise a good set for the price.

Terrible package, you get what you pay for. The best that can be said is that the good is closing and hasn't fallen off yet. I knew this Chinese trick was probably a terrible idea, but it completely exceeded my worst expectations. I did better with a pipe and a hacksaw. You can remove these and slide the old sock over the throttle body instead.

Great product I put mine on when my 8 month old daughter was making a fuss lol very direct. If you have any ideas how to solve things, it's a 20 minute install. USE THE FACTORY GM clamp around the silicone boot and throttle body, it tightens better. Don't even try to connect the metal tube to the screen. Tighten the clamps and you're good. Just buy it lol.

My truck is definitely more responsive and sounds great too. Because others complained about the lack of directions, I got them, but they didn't make any sense. After much fuss I realized that it was necessary to use dust bags from the factory airbox and DMRV. Second, it was too long and difficult to get the plane back in place. No big deal, just patients. I definitely recommend it!

Not a bad cheap cold air intake. Pretty easy to install. It takes a bit of haggling to put it on and the rubber grommet strips around the top of the box are very cheap and don't seal the box in any way. Be sure to clean the oil filter before use. Fit is fine. I don't know if it really helps increase fuel economy or boost performance, but it looks cool. Sonically, I already have a Flowmaster 40 with dual exhaust, so I can't tell any difference in intake air noise. The shoe that goes in the MAF…