Motorcraft CX1775 Idle Control Motor Review

A while ago my wife ordered a replacement for a perfect throttle body from a local shop which was unbranded or wrong. Causes problems. The third-party motor has been replaced with the correct number motor and works perfectly. 8mm socket on 1/4" ratchet. It was possible to replace the valve, but it took time and many patents. The new valve's packaging says "Made in Japan". Jimmy.

2001 Focus zts- Initially the problem was the car stalling at idle. My 1st valve was ordered from a Rockauto brand "stock" box and it did not stabilize idle and was able to hit 50 mph without the accelerator. If the vehicle is disengaged while driving, the vehicle will accelerate to approximately 4500 rpm. It almost killed me because the car was difficult to stop. I then bought a BWD brand valve from Oriellys with similar results. Both valves came with paper seals. Tried with and without…

If you are having these problems with your Ford Focus 2.0L 4 Cylinder DOHC Zetec1. Hard start (requires more than 1 or 2 start attempts of 5-10 seconds or more) and eventually manages to start the car, eventually with the accelerator pedal depressed. Poor idling after engine warm-up and stalling at brake lights3. Poor idle, usually whenever the A/C compressor kicks in4. Regaining strength for no apparent reason and difficult to adjust idle 5. Difficult starting of the engine when warming up6…

2001 Focus zts- The initial problem was the car would stall at idle. My 1st valve was ordered from a Rockauto brand "stock" box and it did not stabilize idle and was able to hit 50 mph without the accelerator. If the vehicle is disengaged while driving, the vehicle will accelerate to approximately 4500 rpm. It almost killed me because the car was difficult to stop. I then bought a BWD brand valve from Oriellys with similar results. Both valves came with paper seals. Tried with and without…

Ok guys I hope I can help those of you who own a 2000-04 Ford Focus gg. DOHC engine. This is my Motorcraft CX1775 review, the actual part number on the part itself is YL8U-9F715-AB or AC. I just installed this Motorcraft IAC on my engine and the engines now idle like new. DO NOT USE Standard or other IAC brands, I am 100% sure they will not work. For that, it costs $121.20. IT WORKS because it is an original part and design. The original idle control valve on my 02 Focus zetec dohc ran out…

If these problems occur on your Ford Focus 2.0L 4 Cylinder DOHC Zetec1. Hard start (requires more than 1 or 2 start attempts of 5-10 seconds or more) and eventually manages to start the car, eventually with the accelerator pedal depressed. Poor idling after engine warm-up and stalling at brake lights3. Poor idle, usually whenever the A/C compressor kicks in4. Regaining strength for no apparent reason and difficult to adjust idle 5. Difficult starting of the engine when warming up6. In the worst