Curve Smoke Motorcycle Handguard Hand Guards: Ultimate Wind and Cold Protection with Windshield Deflectors Review

Would give 5 stars but they are a bit weak. Just don't try to conform (twist your tongue) on the fly. I cracked one of mine 75% all over the plastic. It can be difficult to adjust the angle so that all of the wind is blocked from your hand (riding fist). I live far north and it's convenient.

Quite nice. I don't need skids, but I was looking for a set of smoked bottoms for the front of my 2012 Fatboy. I saw them and thought the size was just right for me. Plus, at about 1/4 the cost of a Memphis Shades set, why not? Spring. Success! They work great and look really cool! Let's see how long they last!

I'm starting to correct as it says it will fit 8 and 10mm bolts. I have a Moto Guzzi V7iii and the mount doesn't fit. I installed a 10mm mirror but the hole for the mount is smaller than 10mm so I had to drill through it with a 10mm drill bit. Definitely I need to make a new mount because the length and height are way off. I do not recommend.

Fits 17 Honda Rebel. Installation is pretty easy, you'll have to tilt it properly for it to fit, but once you've done that it's easy. The material quality is good despite the low price. However I tighten it, it doesn't block the wind at all. It's like nothing was installed. I think I'll keep mine anyway because it looks pretty cool.

Great for a 2019 Honda Rebel 300. There are no instructions. You need to remove the mirror and the bar that the mirror is screwed into. Attach the bracket and screw the eyelet, then put the mirror back into the eyelet. Pretty easy once I figure out the order in which to do it. I had some extra parts that are not needed for this bike. short brackets, two nuts, bolts and washers. Rings to go on either side of the screws.

Just installed them on a Yamaha bolt. I was afraid they wouldn't fit because I didn't see any specific mention of my bike in the description, but they turned out to fit almost perfectly. I had to use a smaller extension on the clutch side, there was no extension on the right side. Installation took about 10 minutes and the hardest part was unscrewing the mirrors and then putting them back on. it's getting hot. Last week I drove to work in my 40's and of course once I put them on the forecast it

Comes at the end of the range; came with no installation instructions. Does anyone else have this problem and if so do you know where to find a good guide on how to install it? Bigger hand protection than expected, in a good way. *Update/Instructions*: You can refer to the product images to understand how to install. Basically put rubber washers on each end of the smaller screws and attach them to sheet metal and bent metal of the same size. sheet metal and on the guard on both guards (you will

The mounts are offset about 2" down (I have 1" caliper mounts) so they are either too high or too low. The smoke tint in the picture is as dark as a pair of Ray Bans, making my lightly tinted windshield look transparent. The holes in the bracket are too far from the edge to use on my caliper so they have to be mounted on the underside of the caliper. I work at a great store so this is an easy fix for me, but this is important information that should have been in the product description…