📦 Efficient Mount Drawer Slides Extension Glides: Enhancing Smooth Sliding Experience Review

I ordered these because I also needed the rear brackets to attach to the front frame cabinets. I was converting cabinet doors to drawers and needed a side/back slider for this particular drawer. My drawer is 22 inches long and my closet is 23.5 inches deep. It was fairly easy to install, probably easier with two people holding the sled flat and level while you mark and drill. Probably the hardest part is making sure the rail is level and straight so the box slides easily over the rail. I had an

Very easy to install, not sure why people say they had a hard time with it. They were literally so easy it took me a full 8 minutes to swap out a drawer. Remember, if you don't have a drill or don't know how to use a tape measure and spirit level - this project probably isn't for you. You need to take measurements and make sure your new track is straight. If you don't know how to do it, then don't buy it and then, out of your ignorance, leave a bad review about the product - it's your fault…

Bought a pair as a "test" to make sure they were of acceptable quality before buying enough for the whole kitchen. They're fine so I'm ordering more sets for the rest of the boxes to make sure they all fit together. A few questions: * There are instructions in the box. They are terrible and useless. Pictures/diagrams very difficult/impossible to read. And the installation process is reversed. I always assemble the cabinet drawer first and then measure and install the drawer part.* Wrong type of

Upgrading your closet with this isn't easy, even if you're a seasoned jack of all trades and know what you're doing. Yes, and it was still a very complex project to set up, align and get fully functional. If they are not installed exactly right, with the correct spacing, level, and front and rear spacing, they will bind or otherwise not function smoothly. However, I dialed them all in and it was so lovely, with a smooth feel and sweet bliss without the slamming boxes. They worked fine for at…

If you use drawer slides frequently, you will find that they are a piece of crap compared to other full extension soft close drawer slides. .Typically, drawer side rails require the drawer to be 1" smaller than the width of the cabinet, with a tolerance of +/- 1/16". These stacked rails are 1-1/16" thick and do not compress to 1". Any shrinkage or swelling of the drawer over time will inevitably result in the drawer becoming stuck and impossible to pull out. Even installing a 16" drawer with a…