📲 Enhanced Marine Electronics Mount - RAM-111U-B with Short Arm: Garmin, Lowrance, Humminbird + More Compatibility Review

I bought this to use on my Lowrance Elite 9. I had to make a few modifications to the mount to get it a perfect fit, but it was easy to drill a few holes. The mount can definitely take the weight and won't give in even in rough water.

Installs my Garmin 93sv UHD. The ram mount worked great. The holes match. Attach the Garmin mount to the bushing using 4x32x3/4 Phillips machine screws, 4x32 nylon insert locknuts and #6 flat washers. All fittings are made of stainless steel. I attached 4 10x1-1/2 Phillips steel sheets to hold the piston on the boat. Everything is closed.

Needed a new mount for a new (used) boat. It came with a ram mount but smaller bullets with a longer arm. This device was too heavy for that, didn't stand up and couldn't be positioned in such a way that you could see it clearly while driving. Got this little arm mount and replaced the old one. It is much stronger and easier to place, fits the space much better. I was hesitant to shell out $50 for something that seemed so simple, but it's high quality material made in the USA.

I used it to install a Garmin 742 chartplotter on a sailboat. The round base connects unchanged to the RAM swivel mount that I already installed and used on my old fish finder that I was looking to replace. The square base fits my new chartplotter without drilling any holes. This device again allows me to hide the GPS in a corner in the cabin when I'm in port. To swim, I release the grip and raise the GPS for best cockpit view with the RAM arm outstretched. This whole setup only takes a few…

Purchased for use on a Garmin 7607xsv used in a boat tower. The turret has an incline and I wanted the device to rotate towards the rudder. This required a complex cut to make the block. I treat her terribly. After lots of sawdust and several hours of converting large blocks of training wood and teak into small blocks, I purchased this mount. It's not exactly the look I wanted, but it works great and is very durable. The 1.5 inch ball is powerful enough for a Garmin 7 device. Will definitely…

I just bought my first full size fish finder. New Lowrance Elite 9 TI2. I was looking for a way to install it and according to the RAM website they recommended a larger 3 inch version for my device which sold for over $100. After spending a thousand dollars on a new card, I wasn't happy paying that much for a light fixture. I decided to take a risk and all I can say is that it's LONG LASTING! I decided to install it on my console and I like how it turned out. When I first installed electronics…

I used this to mount my Garmin 742 chartplotter on my sailboat. I already installed it and used it on my old sonar that I replaced. The rectangular base fits my new chart plotter even without drilling holes. i'm in port To swim, I release the grip and lift the GPS up with the RAM arm outstretched for the best view from the cockpit. This whole setup only takes a few seconds. It could hardly be more perfect for my needs. And, of course, the quality of the main memory goes without saying.