🔧 Enhanced Mr. Gasket 1283 Coil Spring Twist Set - Pack of 4 Review

My front driver's side spring ran too low on my '64 Chevy C10. 10 minutes later. Jacked up the frame, put one in and boom! Car leveled again .

I bought these for the rear coil springs on my Toyota Avalon but without some serious work they won't fit, not worth it. This is not a quick and easy install as it seems.

Raise my 1988 Jeep Cherokee 1 inch up front. I used 2 blocks on each side of the front springs. It mounts on top of the coil springs. Tight fit but works. My Jeep doesn't look like a professional off-road vehicle anymore!

My 2003 Silverado front end sagged about 1-1/4" on the driver side compared to the other side. I installed 2 of these washers in the coil spring on that side and they aligned to 1/8" on the other side. It's looking a lot better now. A simple and inexpensive solution that doesn't affect the ride at all.

I installed them on my 1987 Dodge D150 and they didn't lengthen the springs at all. Sure, it was a quick and relatively easy install, but I see absolutely no difference in truck fit. Also, when I requested a refund from the seller, I was told that my request was denied because they had been in use and they were "out of the return period".