📏 Mr. Pen- Wheel Marking Gauge with 2 Extra Blades - Woodworking Scribe Tool for Precise Marking, Woodworking Gauges, Marking Guide for Wood Projects Review

CUTTING DISCS DO NOT CUT. At best, they make a recess on the workpiece. THEN YOU CAN USE THE STRAIGHT LINE TO GUIDE THE MARKING KNIFE TO CUT THE LINE. I tried sharpening the disc on the diamond plate. BOR WAS NEARLY IMPOSSIBLE TO REMOVE. UNTIL THE BORON WAS REMOVED, THE DISC WAS AS SEALED AS PRIOR TO WORKING WITH THE DIAMOND PLATES. I HAVE TRIED THEM ON PINE, ALDER, MAPLE, OAK AND CHERRY, NONE HAS A CUT LINE. SAVE YOUR MONEY BY SIMPLY USE THE MARKING KNIFE TO START.

t mark out of the box. The screw is not blocked with one hand so you have to get a third Put your hand to keep the sensor distance at the same level, and also screw it with two hands without losing the mark, because the sensor is quite loose without the screw tightened.In general, it is difficult to operate, but it can be improved by some adjustment I advise you to place this sensor on a table with the screw on the edge of the table so it doesn't roll off the edge of the table as it is light…

Leaves a nice clean sharp line, the major downside is that it's almost impossible to read the markings on the depth gauge rod without perfect lighting. I've found that I have to use a combo box to set the depth, which just exposes you to inaccuracies. Also, there are no marking differences between half-inch, quarter-inch, etc. lines. As usual, half-inch lines are larger than quarter-inch lines, and so on, with eight-inch lines being smaller than quarter-inch lines. On the shaft, all sub-inch…

The threads on the handle are so badly formed that the handle wobbles in the handle and only catches the handle threads on the last 1/2 turn of the handle, but that will happen too probably not last long. I will therefore return the item as unusable as soon as possible. The markings on the shank, while relatively accurate in relation to the blade, are barely visible except with reflected light at a certain angle, and are therefore not easy to use. Metric markings have an incorrect additional…