🔘 Nilight 90106B 2 Gang Rocker Switch Panel - 5 Pin On Off Pre-Wired Rocker Switch Aluminum Panel - Waterproof Switch Panel for 12V/24V Automotive Cars, Marine Boats, ATVs, Trailers - 2 Years Warranty Review

They click and look good, but cons: - The switches don't sit flush with the trim plate - The pins on the back fall out very easily. Not suitable for automotive or marine applications with vibration - internal switch fails very quickly. Our first switch lasted about a month with very little use. Poor tolerance. Two identical switches shipped together will fit differently.

It's been in use for a few months and they still work great and look great. They are of exceptional quality. The little sticker probably won't last long, but the stickers that come with it shouldn't be the reason you're buying these switches. If you want the light on the switch to show exactly what it is for, I would buy switches with a built in picture. For the money they are great! I highly recommend

I bought these to fit my 2007 Nissan Titan. The Titan has pre-cut locations for the switches, although I had plastic caps, no switches. I removed the caps, took the switches out of the panel they were on and was able to insert the switches straight into the precut switch positions! LOOKS GREAT! The rocker switches I bought were a bit larger than the factory switches and protruded a bit, but I'm okay with that, they look big and stiff.

I ended up using them for PC geeks (don't ask) on 12V. First tried with 5 volts, then with 9 volts. It glows fairly brightly at any voltage. At 12v the light is pretty bright but if you stick one of the stickers on it (which seems to stick really well) it's the perfect brightness. Most of you will use this for vehicles/boats. They can be used for almost anything! Remember, volts don't matter. The strength of the current does. Not sure why they don't list it, but I suspect up to 15 amps should…

These switches exceeded my expectations. I wasn't planning on using the bezel they're mounted in, but I'm reconsidering my decision now because the bezel is about 3/32 inch thick aluminum with a nice matte black finish. The switches are crisp, but not too tight at all. For those of you using the setup as is, it is pre-wired so you only need to connect positive, ground and then positive the load you want to control. These switches match the style of switches in my skid steer loader and tractor…

Bought. There were damaged loose parts rattling in the switch. Returned. Looking around, I decided to try again. Connected as plus to plus, minus to minus, load to load. A lamp is constantly lit. The other set works perfectly. I can't find anything to trace the wiring harness on either set. Start by checking the wires with a multimeter. The same set is always hot. Check switch Switch is defective. Pure garbage. A hole was cut in the dashboard so now I have no choice but to order another one. It