Omotor Chevy Anchor Truck Bed Tie Downs Set - Secure Cargo with 6Pcs Anchors for GMC Sierra, Chevy Colorado, GMC Canyon Model Truck Beds Review

These anchors go really well with my 2020 Silverado. This 6 pack filled both sides of my bed. With my transfer tank I didn't need the front of the bed. They appear to be much sturdier than the side panels, weighing 250 pounds each and making a great fit for the zip ties in the middle of the bed.

2019 Chevy Colorado short flatbed with factory body upholstery. The product was exactly as described. Installed all six in less than fifteen minutes. When the weather gets better I'll cover the light screw heads with black spray paint - just for aesthetic reasons. Would buy again and I might if I see the need to add two more on each side in the lower positions before the strikes.

Price liked, about 1/3 of OEM price. I didn't like the size, needed something more. It's quite difficult to get a wrench in the middle to get a nice fit. I think they will hold up well for my recreational use but I don't think they have enough contact area to handle heavy loads. The hook size can be slightly larger to accommodate more than one or two straps. I've only had them for a few days but I think they will meet my needs.

Installation is a bit tricky but after the first install it didn't matter. Insert it, rotate the bolt 90 degrees and back out so the "nut" is against the inside of the bed, then tighten until the nut is past the post that holds it on Rotate and you're done. I like how they look installed and it would be nice to have additional mounting points. The only downside is that one of mine is missing the foam pad and when you try to get support the site comes back without a security certificate and…

These rock anchors are good value for money. They are relatively easy to install. You will need a flathead screwdriver to remove the cover from the truck bed. Attach the screw to the bracket and tighten until the screw shows through. Don't forget to attach the foam pad to the anchor. Position the latch parallel to the anchor and insert it into the hole in the truck wall. Turn the screw clockwise and pull out until the bracket is seated. Finger tighten the screw and complete with a 1/2 inch…

I knew I would be moving a lot of furniture and needing more storage space in the coming weeks. For some reason, GM just placed them at the bottom of each corner of the bed in the 2014+ Silverado. I've looked at GMs but they're very expensive and I don't care how they attach to the bed wall. I saw these and decided to give it a try. I almost sent them back because I only got 5 instead of 6. I emailed the seller and he replied that he would make an order of four pieces. Well I got the extra…