OnReal Battery Motorcycle Detector Alligator Review

【Checking the dynamo】 Connect the testing device. Start the engine and switch off the headlights,radio etc. Start the engine again and switch on the headlights, radio etc. In both cases, the green signal lamp“GOOD” must shine. The red signal lamp “Fault” will start to shine if the dynamo supplies no or very little voltage. Please check that the tester is connected correctly. Otherwise contact the car workshop. 【Checking the charging level】 Switch on the headlights for 1-2 minutes,then switch off again.Remove the cable clips from the battery, wait approx. 10 minutes and then switch the testing device on again. A signal lamp will shine according to the charging status of the battery indicating “FULL”“HALF-FULL” or“ VERY LOW CHARGE”. 【Start capability of the battery】 The battery needs to be charged up to the maximum. Remove the connection of the ignition coil and then connect the testing device. Try to start the vehicle using the key in the ignition switch. The engine cannot start(interrupted ignition).When the green signal lamp “BATTERY OK” starts to shine, the charging status of the battery is OK. 【Easy to operate】 Clamp the red and black test clips of the tester on the battery under test, connect the red to the positive pole and the black to the negative pole, and the corresponding LED indicator of the tester will indicate. (Note: Do not operate for too long!). 【Scope of application】 It can quickly detect the car battery and charging level, and have the corresponding LED to display. Suitable for 12V batteries for battery cars, motorcycles, golf carts, family cars, etc. (except for buses and trucks that are 24V batteries). The operation is simple, easy to use and safe. The internal security chip ensures stable operation, high temperature resistance and low temperature resistance.