🚤 Enhance Your Boat Cover with 1 Pack - Boat Vent Cap 2 Review

These were replacements for two that I broke trying to remove a lot of snow from a pontoon boat cover this winter. They fit snugly and are easy to assemble. The product meets expectations and was delivered on time.

All I did was cut a 2 1/2 inch diameter hole at the mounting post location and then cut it out with a utility knife. The ventilation hole is screwed on and clamped on both sides. insert a bushing into my post but I knew that would be the case. Very good value for money and easy installation.

Very easy to install once one piece goes under the cover, another on top and you screw them on. Great replacement for our originals, they are strong and hold up pretty well, they have survived this summer with no problems and we always keep our boat covered when not in use. very satisfied with the product.

You simply make a small cut in the tarpaulin and twist the halves together. Then install the correct length pole for that spot in the boat and you have another support for the boat lid. For years I have had depressions in my mat that heavy rain has filled in which puts a lot of pressure on the mat and I have run to scoop water out of those depressions. I installed this extra lid support and permanently fixed this issue. Why have I waited so long? Choose a support post (I cut an old broom handle

I had a small tear in my expensive pool cover and bought this with the main intention of using the 'clip' feature to fix the tear/fabric stick together and don't let it break down any further. This little cap more than holds it together, and while my teardrop wasn't exactly centered or where to place a support post, I ended up using it for one. Helps prevent rain from rolling off the back half of the cover. I notice a slight temperature difference under the lid, but it's still terribly hot…