🔌 AM Brand - 2-Pack 1-Inch Slip Slip Bulkhead Twin Pack Review

I very much doubt that it is actually PVC. Using any PVC glue will produce a black tar and horrible smell that is much stronger than the PVC glue itself. The filling looks good at first, but the chemical reaction with the glue will continue until it melts.

One worked, the other had something threaded and it doesn't hold. Very pointed out by Dodds. I ordered a replacement and it took them 4 days to even ship it even though they promised Prime. If I were you I would avoid this company.

They work great in my aquarium and seal tight. Are the pads included in the kit softer than regular rubber, maybe polyurethane? Anyway, they don't even think about the leak and have been working for several months without any problems. The threads hold tight and this allows me to pour more and more money into the somewhat thankless saltwater fishing hobby!

I used them to control the flow of water from a Plexiglas dam I built on a natural spring in the Rocky Mountains. They work exactly as described. I used a 1 3/4" hole saw to cut a hole in the PVC and this piece fit very well. I also used acrylic glue to seal it around the perspex holes. .

There is definitely something wrong with three of the four I received. When gluing the PVC pipe I had no problems with primer and glue. Whenever I glued this bulkhead, the glue never held. The inside of the bulkhead looked like mush. After 5 minutes, when I was no longer holding it in place, I could easily twist it or even apply some pressure to separate the joint. After careful inspection, the glue on the pipe (inner layer), not the outer layer, was hard and the outer layer was soft or…