Performance Tool W54240 Grease Fitting Review

Very good quality but I couldn't use it as it didn't fit the mandrel on my Husqvarna lawnmower. The correct size is 8M. To return.

I needed 90 degree grease fittings to allow easy access to the Moog inner tie rod ends. 1/4-28 was the correct thread size for the tie rod ends.

I bought these to replace the needles on my JKS Away circuit breakers on my Jeep. Worked great and the old ones were such a flatbread I'm willing to disassemble and replace over and over again that gave me five sets.

Don't waste your time and money. They all flow. Some flow at a 90° angle, others flow back through the spring hole. I used 5 of these, each leaked. I'm waiting for another brand to take it off and send it back. waste of time and money.

Perfect for replacing a broken SLR on one of the Bearing Buddies on my boat trailer. To replace the mirror on the bearing partner, you must remove it from the wheel hub, as there is a nut inside that you cannot screw the mirror on from the outside. This is easily done by tapping the Bearing Buddy on all sides with a hammer until it comes loose. After that you will need two 5/16 sockets to remove the old plug, one for the plug and one for the nut inside the bracket. After replacement, slide back