Peterson Manufacturing Silver V298C License Review

Good product, well finished and sealed. As far as I can tell, the results aren't polarized, so there's nothing to worry about. but big deal. Shipping could have been a bit quicker from the seller I bought from but I took my time so no mistakes.

Used on an Old Ranch Hand Bumper. Fits perfectly in the hole. Appears to be waterproof unlike the old style it replaced. It's very light. The wires are brown and white, not red and black. The polarity doesn't matter. So if you connect the brown wire to + or the white wire to + and the opposite to negative, it will work and the car fuse will not blow.

My truck had some sort of aftermarket bumper that sat there forever and used these little round "trailer" style universal lights. They used to be very weak, and then they just went out. I have no idea how long because I didn't know that beforehand. someone. told me. In any case, these lights are quite bright and go well with the spot. I had to add a ground wire as the original lights used the base as ground and they have a ground wire.

Used to replace the factory bulb on a pickup truck. Easy installation. It took about 3 minutes. The old lamp had a wire. This one has two. I just stripped about an inch of insulation from the end of the white wire and wrapped it around one of the pins that go into the hole in the bumper and attached the dark wire to the original wire. Then simply push the lamp into the hole in the bumper. He stood up immediately and fitted perfectly. It has a very clean white light that illuminates the license…

The headlights fit snugly in my 1969 Ford F-250 bumper hole which is 1.25 inches. Lanterns have flexible protrusions placed around the perimeter. to hold them in place except where there is a gap to place a tab in the bumper hole which will align the lights properly and prevent them from rotating. There are two wires, one for voltage and one for ground .I used the white wires to connect to voltage with dielectric grease and crimp the ring terminal to the brown ground wires with license plate…

Pro:1. can be connected in either direction.2. Fit is great. firmly in place. I have a 1990 Ford F150 pickup with 2 headlight holes in the bumper.3. The LED block is completely sealed in a plastic lens. As such, the LEDs shouldn't get wet, which is good when you get 50 inches of rain a year. Boot.5.Quality seems pretty good. Being new I have no idea how the assembly will hold up to years of corrosion but for the price it's very good value for a complete assembly with LEDs. Cons: LEDs cannot be…