🔌 5-Inch Corrosion Resistant Electrical Fiberglass by Pixiss Review

They looked great. The concept is great, but the quality: an epic fail! Each fell apart within seconds of first use. The actual handles are not glued properly. Poor brush control. They just drop out. The best part about this purchase was the plastic bag they came in. The only thing that didn't end up in the trash!

Итак, я купил это, потому что получал уведомления о том, что мой Pixel 3 заряжается/подключается к USB, хотя на самом деле это not so. . Apparently this happens when the wires start to rust. I bought this and use bronze, nylon and then fiberglass brushes. Not sure which one worked, but seems to have been fixed. The USB connector is hard to see, so I'll just skip to the error messages. I will revise this review if this is not fixed. The brushes themselves are cheaply made but offer good value…

I like this set because everything that runs on batteries sooner or later forms an invisible film (sometimes visible) that interferes with the battery's contact in the circuit. After sanding the surfaces with these scraping brushes, we restored our electric fireplace's flashlight, sharpener, and remote control. In addition, they have repaired other battery-powered devices where the battery was badly leaking and corroded. You will receive a brass thread scraper, a steel thread scraper and a…

I ordered the whole set just to get my hands on a fiberglass brush for scraping electrical contacts. I had ONE that I used for at least 10 years but I had to leave it at work when I retired. a little, and a tiny spot of rust appeared on the blade of the knife. The fibers have disappeared in the pen body. Rotated at the top of the feed knob. nope Nothing. He took the end off and there's a bundle of fiberglass. It didn't move except a tiny bit, and turning the knob did nothing. So I think I have.

Media could not be loaded. I just found out about these "cleaning pens" so I bought this small find cleaning kit. I liked the price for 4 different cleaning pens. I don't have a lot of loose items to clean. However, if I did I would be concerned about the amount of filler in the handle (brass, steel, nylon, fiberglass). The amount shown in the photos is the actual amount you will receive, approximately 1 inch. In the photos you can see the remains of the fiberglass handle. It and all the others

Received today. We ordered them to clean the old flashlight that we love and can't replace. Started with brass wire. It fell apart within the first 5 seconds. The wires fell out and rested on the handle. First I managed to get her back. But after about 3 minutes they were back in the enclosure and not moving. Next came nylon bristles. When I took it out of the packaging, it fell apart in my hand. I was able to put it back together in minutes before it fell apart again. Needless to say, the two…

Tried all 4 pins, although all I really needed was fiberglass. Brass and steel handles hold up well, but you shouldn't start scratching anything with metal right away. A nylon brush is useless. You might as well buy a $1 baby brush because you won't scratch anything with the soft edges of this nylon. Finally a fiberglass grip. I tried removing about 1" x 0.5" of the PCB cover and it did NOTHING to remove the cover. Once I scraped off the top layer with a separate metal spatula, I was back on…