Enhance Drawer Functionality with 6 Pairs of 17mm Grooved Plastic Rail Drawer Runners, 300mm Length Slides Review

It is very difficult to install these skids correctly because the plastic seems hard but is actually too flexible. When inserting screws, the conical hole will be pushed up or down by the screw head unless the screw is exactly in the center of the hole. This causes the plastic bar to flex slightly, causing the drawer to bind rather than slide smoothly. Because the screw hole is larger than the screw shank, it is nearly impossible to center all four screws. This could have worked better if a…

I had a pine Ikea dresser that had a couple of broken plastic drawer slides. Numbers (320x?x?) were printed on the slides, an exact replacement could not be found. They looked the same so I took a chance and bought them. They were EXACTLY the same length even though they were marked 300mm so I have no idea what the difference is, but they were wider than the originals (side to side, not "height" which is slot width, through which they glide). on the). If I used 2 I wouldn't fit in the drawer…

I have a flat dresser from House of Denmark. Bought by me in the early 1980's, teak veneer, holds up remarkably well despite various movements. The sliders on the top drawers were removed so I ordered them. You are too fat. On the chipboard side I put them in a vise, not too tight, and saw off about 4mm from that side with a hacksaw - you can't do it all at once, but you can do it with a bit of plastic shavings. And they will do their job. I'm taking off a star because they're cheaper than the…