PointZero Pro Airbrush Air Compressor Regulator with Water-Trapping Filter Review

The only complaint I have is that the pressure gauge doesn't point in the direction I'm working. I need air ducts coming from the right side. The sensor is rotated backwards and is not visible from this position. It cannot be loosened without deflating, nor can it be tightened more tightly than it already is. If you installed it on the left side, then this will not be a problem for you at all. Aside from that one thing, it does exactly what it's supposed to. Gives me consistent air pressure…

That's not bad for a regulator, but if you're buying this for free e-books, don't! I've looked everywhere for advice and to find out where the ebook links are and I can't find it, someone even asked exactly where to find the links and the only answer is they suck are! Go to YouTube, it's better but still doesn't tell you how to find ebooks. I found them a lot cheaper without the eBooks but I paid knowing I was looking for any tips and tricks I could get and it said 8 different books. So I spent

Works great once I figure it out. When I finally found all the fittings needed to run my compressor, it didn't seem to adjust anything. Out of the box it was set to "wide open" and the setting was not rotating. After playing around with this, I found that the adjustment knob needs to be held firmly and pulled up until you feel a click. It is now unlocked and can be customized. The attitude is somehow illogical. To decrease the pressure, turn the knob counterclockwise. This will take more twists