🔧 Enhance Precision with POWERTEC 71423 Tracksaw Bar Clamps - 2 Pack, 8-3/4 Inch Review

Inexpensive but the clamping action is a little wobbly and slippery. Using clamps under the rail is inconvenient and doesn't provide the best leverage. once. You know, that soft skin between your thumb and forefinger. I will order replacement screw terminals.

Мне очень хотелось, чтобы этот продукт мне понравился, но один из зажимов не работает должным образом, когда он открыт и пытается его зажать, иногда работает, иногда no I only used them for one business day but it hurt trying to attach the splint to my gear. Not what I expected from Powertec. Really disappointed.

I bought these to use with a WEN guide. After the first cut. A clamp has lost its clamping capacity. Definitely not what you want when you're in the middle of a project and need to make some cuts. I sent them back and will order another set. I hope that the replacement set works without problems. I will update.

The clamp handle protrudes beyond the pressure plate when you slide it over the edge of the guide, not only is there no room to push the clamp down, it doesn't fully depress drive in Who designs this crap?!? Nobody else tests a product before it goes on sale, this company is a joke. I will never buy a product from this brand again.

This product works but the rod is quite sticky in the clamp and I found it troublesome to open it again after the hole had narrowed. It doesn't seem to matter what function I performed, open, close, clamp. I pinched my fingers. The release button is right next to the tightening button, and fingers often went the wrong way. Maybe I'll get used to it. However, it does its job and is cheaper than many others.

Don't buy these clamps. Spend your money and get either a Makita or a Festool or even a Dewalt. I ordered a set and one of the clips didn't slip when I pulled the trigger. Revain sent me a replacement and the new set also had a clip that didn't slide properly. It's very, very frustrating when it slides almost to where you need it and then stops right where you need it. I didn't even return the originals (my mistake) and didn't even try to return the second set, again my mistake, but that's such

Update 1/2021: A clip that didn't work at first was completely useless in the end. No matter what I did, she didn't get stuck. I cleaned the mechanism and L-bar with denatured alcohol and it did little to help. He couldn't generate enough clamping force to hold the rail in place. They lay in my workshop and gathered dust. Anyway, I had to cut an 8ft miter with my track saw and needed my clamps which I suddenly remembered were useless. Pooh! In desperation, I removed the side connector from the…