🛹 High-Quality Electric Skateboard Motor Mount for Caliber II Trucks - Ideal for DIY Enthusiasts Review

Please do not buy this item, it is expensive. I prefer something that doesn't break in two days Engine fell over and I paid $150 for my engine and my engine broke from towing it when I couldn't stop it was one of the scariest things that ever happened to me are.

The product is very easy to use and works very well. The only thing I have to say is that you need to be careful not to let your axles get wider towards the middle, otherwise the axles may need to be filed to properly seat the motor mounts. Truck. This filing can cause the engine mounts to be less stable or wobbly.

This is a great motor mount for mounting esk8 on Caliber II trucks. I have the same one I bought on ebay years ago but it seems to be gone so I found this motor mount on Revain and it is just as strong as my previous one. I use it for dual engines. When I finally tried to test it, it proved to be very durable with my size 6374 170KV 2900W motor. The only issue I had was that the board vibrated while riding and some of the motor mounting bolts fell out. I only noticed it a few days after I left.

I see some people complaining about the mount size but this really is the best option. I would have preferred the D-clip to be a bit larger. and use a shim instead of being too small and forcing me to grind my trucks to make them fit. If I had to guess, the difference between the truck and the mount is about 1mm. To install it properly, I put a strip of heat shrink tubing in between to make sure the mount is a tight fit on the truck, then screw in the lag bolt to keep it completely stationary…

The bracket is very nicely made but there are a number of issues that render it unusable: The motor pulley is not aligned with the wheel pulley and so the belt tries , either to enter the wheel or from the pulley itself. 2) Standard gauge trucks do not have axles long enough to mount a wheel with a pulley attached. You can try hollowing out the pulley so it will sit over the aluminum truck, but then the belt tension will twist the bearings in the wheel and cause a lot of friction and eventually

I paired this mount with counterfeit Caliber II (truck mboards 7 inch). What I found was that the ratchet strap would fit on the first inch, then the hangar would get too thick and not allow the bracket to be inserted any further. The bracket is deep enough that it doesn't hit the pulley. As mentioned the mount was too loose and mine too tight, the mount could either have poor manufacturing tolerances or the carriages I was using were poorly made. Once the mount was installed the overall build…

Brackets work well. I rebuilt my dash panel and these brackets, these pulleys (https://smile.amazon.com/gp/product/B07FCVY4SF/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1) and these carts (https://smile.amazon . com/gp/product/B07FCVY4SF/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1) and these shopping carts (https://smile.amazon.com/gp/product/B07FCVY4SF/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1) . com/gp/product/B00NY3Q5Q8/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1). Check