PrimoChill Reamer and Deburring Tool for PETG and Acrylic Review

If you want to add burrs and rattles to the end of the pipe then this tool is for you or else you'll save your money and buy something else.

works great i was concerned the block is only plastic but after 100+ uses it works great, worth the money would buy again although mine still works great

This is just anti-PETG babble🙁. The hardness of the "blades" (higher hardness plastic) is not great enough to bite the ends. I wish I had bought it from the seller as I am now stuck with an overpriced piece of junk. Stick to drill-type finishers.

Bought this to mold PETG tubing for a special loop on my new PC. It was very simple and easy to use. The left pipe ends are smooth and have not damaged any of the o-rings on any of my fittings.

I am looking for a deburring/reaming tool from Revain because I bought it at a micro center and one of the "blades" broke while expanding the 3rd PETG tube. I say blades because blades are made of plastic. Metal-bladed tools work much better.

is purely a plastic tool. I've used it on acrylic and it did the job well. Build quality isn't great with some of the plastic being completely worn away or showing weird issues, but there are some parts that don't exactly make contact with the pipe. In any case, it continued to work after 15+ whistles, but I don't think at the same angles as before.

Ideal for PETG tubing for PC water cooling. Rotating the tool in just one direction gave me really clean results and the hoses went straight into the fittings with no problem.