📱 2020 2021 Ford Explorer 10.1-inch Touch Screen Protector: Anti Glare, Scratch Resistant, Shockproof – Flyingchan Review

Easy to apply and works great. Take your time getting dressed and use a credit card or something with a hard edge to pop bubbles. Works great and no problem

Nice case. But the corners don't match the screen. The lid has a smaller radius so the lid protrudes a bit over the screen and the lid breaks as shown in the picture. Although the display is fine. I will try again

This product is very easy to install, just understand that there is a top and a bottom. It has been found easier to insert the base first and orient the rounded corners up. The instructions could be a bit better, but if you can put on a cell phone screen protector, you can do it.

I was so happy to get it. After cleaning and drying with the pouch provided, I installed the glass and had a bubble that wouldn't come out. I used the squeegee I had and it still didn't come out. I can't imagine driving a new car with a bubble on the screen.

Just remove the protective case and place it on the screen. However I couldn't find any actual dimensions when ordering other than saying it was a 10 inch screen and the Ford Edge 10's screen was 1/4 so I figured I only had 1 at the top and bottom /8 inch spacing below. The actual screen dimensions were only 9 1/2, not 10, so I ended up with a bit more headroom than I wanted. It only covers half of the top row of symbols if you cover the entire bottom row; It's doable, but don't expect full…

Overall this is a great product. It could be improved with your instructions, but you need to pay special attention to each corner: the bottom one should have edges and the top one should be rounded/curved. If used incorrectly you will find that it does not sit flush. Like any tempered glass screen protector (similar to the ones I've used on my phones) it offers excellent protection and wipes smudges off easier in my opinion.

Perfect fit and easy installation on screen. My only advice is to put the bottom part in first, it should go slightly under the dashboard plastic to line up with the top corners, but it was easy to get it in there. I was nervous about the bubbles, but there were no bubbles and you can't even tell it's on screen. The instructions say it comes with a plastic card to pop the bubbles but I didn't have any. Just used a credit card to smooth things over. I also wanted to add one end has rounded…

I was very happy when I found it. I found it quite frustrating when opening it and during installation. But it actually worked out quite well. I had a few buddies with the install but I was able to kick them out. There are a couple of issues. Hope this helps others. It has a top and bottom, the corners are not symmetrical. So it's possible to turn it upside down when there's actually another view and it looks like the poor guy turned it upside down. It would be really helpful if there was some…