🔴 Enhanced Performance Red Rear Spring Eye and Shackle Bushing Kit by Prothane 18-1002 Review

My springs contained larger bushings on both ends so only half of what I needed was included. I don't see any SKUs or sizes to order additional bushings for the other side, nor small ones either.

The quality of these bushings seemed decent but they didn't fit my 1988 4runner, the front suspension bushings were too large in diameter to fit the leaf spring tab, even after removing the metal bushing from the spring tab. The inner diameter of the hole in the smaller shackle bushing was too small for the shackle pins to slide.

I add an extra leaf spring to my OEM springs. Haven't installed it on my 4runner yet but looks like they fit OEM leaf springs. For the bushings in the back/yoke area, 8 smaller bushings will fit after you remove the OEM grommet. For the front hub, you need to remove the metal shell from the front hub to install a new one. Add some PB Blaster around the metal ring. Leave on for a few minutes. Then use a 27mm impact socket and an extension to knock out the factory socket with its metal case…