Pullout Replacement Kitchen Faucets Beautiful Review

I bought this item to replace my kitchen faucet. After hours of searching and reading reviews I decided on this product and was not disappointed. The description matched what I needed to replace perfectly and it took me literally minutes to detach the old hose and easily install the new hose. .Recommended if you don't want to replace the OEM product as it will fit the bill and last a long time!

After the frustrating experience of visiting Ace and Low looking for a replacement hose, I finally bought a hose with multiple adapters (none of which fit). Luckily, this fake worked for a fraction of the cost of the kit, not to mention the cost of calling a plumber. Revane received it the next day. Can't comment on durability, but the hardest part of the install was getting onto the floor under the sink; the "Quick Connect" end snaps directly into place.

We first tried Home Depot's "Universal" hose with myriad nozzles that did NOT work on our 8 year old Moen kitchenware, despite the packaging promising Moen compatibility, so this was a lifesaver (try no plumbing in the kitchen if you doubt me!) the only reason it doesn't get 5 stars is because the tapered part, which should have been 9/16 inch, Seems a bit bigger now so doesn't squeeze inside like it's supposed to so the faucet sags a bit but works without dripping which is very pleasing.

The hose is the perfect, inexpensive, identical replacement for my broken hose that was leaking in the shaft line. BUT THE OUTLET that the hose is plugged into has also started leaking from the opposite side and is a PERMANENT part of the entire faucet body. Since I didn't want to replace the entire faucet set, I cut off the top side pipe and worked with the extra pipes and clamps, which worked. I would like you to also provide (sell) an aftermarket replacement bushing and tube that can be…

We bought a 150259 pull down hose from Costco for a Moen faucet about 4 years ago. Same problem as the old one, an invisible leak appeared somewhere along its length. This new one was 1 inch longer and the ends looked the same or even better than the original. Better, refers to the end of spraying. Compared to casting lines, metal casting has an absolutely smooth surface. small detail. This new hose feels lighter, more flexible and bends more easily. The diameter didn't seem much different and…

Pros: Good length, everything fits and screws perfectly, looks solid. I only installed it for about 2 weeks, so I can't say anything about the quality and durability yet. Cons: It is SMOOTER than the OEM Moen hose. I know this because when I put the initial weight under the sink, the weight immediately slid down. This is a problem for two reasons: 1. Since the weight on the hose is not heavier, the hose cannot easily return to its place after being pulled out from the faucet body. It will…

This is NOT a Moen hose but it is compatible. The hose differs slightly in that it has a smooth hose in a plastic braid, while the original Moen hose had a ribbed plastic hose in the braid. I believe the ribbed hose was the cause of my initial failure as the weight being clamped to retract the faucet head ruptured the hose underneath. Because of this difference, this new hose has a slightly smaller overall diameter (does not affect water flow). I had to use a few turns of tape just under the…