🎨 Lightweight Wood Display Easel, Natural Oak - Quartet 41E Review

This might be the most ridiculous thing to build. I've spent the last 30 minutes deciphering instructions that are worse than the worst Ikea instructions ever! Diagram B shows the top of an easel with ends other than those shown. In this phase, you basically proceed according to the trial and error principle. I should get a medal after successfully assembling this easel. Quality - light weight and relatively solid build - worst experience ever! Recommendation: Buy two and build with a friend…

Fairly difficult to assemble 1) There are three different sized SML screws, three small ones attach the legs to extend the chain at the front. You can turn this screw forward again so you can screw the twisted part to the chain, otherwise it may fall off. 2) the middle one fastens the top part, the cut sides go towards the middle (see photo). Make sure all three sides have the same forward overhang. 3) A long screw goes between two short blocks of wood. The small one will rest on the ribs of…

The instructions are terrible. Here's Manuel: The parts come in a 5" machine screw, a 2.5" machine screw, and 3 x 1.75" machine screws. Here are the instructions. Insert a 4 inch machine screw into the holes. 🤔🙄 Here is the first confusion. Where is the tf 4 inch screw? Second confusion, they probably meant 5" but the 5" doesn't go through either of them so you need a screwdriver to push it through although it says DO NOT use tools. Third confusion, find the top legs of the 6 legs. Finally…