🎮 Enhance Your Gaming Experience: E-MODS GAMING 2X Replacement Analog Stick Thumbsticks + Tools for Dual Shock 4 PS4/PS5 Controller Review

The product is almost perfect! The only issue I had was the screwdriver that came with it. The moment I started unscrewing, the screwdriver slowly began to break. So I decided to just buy one set of screws for this project. The rest of the project went smoothly. Highly recommended!

I like these replacement parts although I think I dented the joysticks quite badly from having to replace the spare on the left joystick after a few months. Also. I know a lot of gamers don't press the motion control stick, but if you're (like me) this is a good factory replacement for the joystick's rubber pads. same problem with wear.

My original Dualshock 4 started to peel off the analog sticks, the rubber coating was peeling off. I just installed these new sticks in my Dualshock 4 and they work great. As other reviewers have noted, they appear to be stronger and more durable than the factory sticks. However, they are almost identical. You sit at the right height, you have full freedom of movement and the click feels the same. It's hard to say if the durability will hold up over time, but I spent about ten minutes playing…

STARTING Using a Phillips eyeglass screwdriver, unscrew the 4 screws on the back of the DS4. Gently hold the triggers in place and away from the case when removing the controller to open it. Next is a clip INSIDE to connect the halves. After removing the battery, a clip comes to the touchpad. (It's a little harder to remove and put back, it's in a hard-to-reach place) Next is a silver screw behind the battery compartment. Gently pull the joystick platform up and out. The joysticks are pressed…

Have only been using it for a few weeks. My original joysticks were a bit worn and torn. **They work great**. We recommend watching some videos on how to disassemble the PS4 controller as there are some tricky steps (initial disassembly of the case and basically the springs on the L/R 2 buttons) to get them. It takes about 10-30 minutes unless you lose the spring or reassemble it incorrectly (some internal connections are very flimsy and tiny pull/compress strap connections). I can't compare…