🌈 Optimized RGB Strip for PCs - Set of 3 Magnetic LED Light Strips for Computer Cases with 12v 4pin RGB Header, Compatible with Asus Aura, Asrock RGB Led, Gigabyte RGB Fusion, MSI Mystic Light Review

My only two negatives: I wish the sleeve was a long box that the strips would fit in so they don't curl up. This would make installation easier so they don't try to curl up. Because of this, the strips can lift a bit despite the adhesive, so I'd wait and make sure it doesn't before heavy workloads. I haven't noticed any further increase since I let the glue dry. I also suggest holding the strip in place for 30 seconds with the same light pressure. Be sure to wipe the area with alcohol before…

*Not a paid review* Here is my honest review on this product: These RGB lights are amazing and super bright too. There are many different lighting modes as well as many different colors that you can change with the remote control. The installation process was easy. I'm taking off 1 star because the tape isn't as strong as I thought it would be. The strip detaches towards the end of the strip so you have to constantly push down to keep the strip in place and not unravel again, so I found my own…

I bought this led strip because I needed three strips (many Revain packs only have two in the box) and it comes with a three way cable. I use it with ASUS Aura Sync and it works without any issues. All the LEDs work out of the box, they are long and bright. My only complaint is that I wish the magnets were stronger. I don't need glue (I don't want glue sticking to my case) but I do need a stronger magnet so the strips stick better to the metal case. I haven't had any instances of the strips…

I took these because they were cheaper than others. They are lighter than expected and well made. The magnets aren't very strong, but the adhesive on the back of the strips works well. I only have two problems with them. First, they come with a triple splitter cable, but also an extension cable. I don't mind using a splitter, but give me more than one extension. The pins are not removable, so the splitter MUST be connected to the motherboard and the extension MUST go between the RGB strip and…

Bought these lights before but in packs of 3+ strips. For the smaller ITX case it only took 2 this time and apparently that was a mistake. Overall lighting is good (although the glue isn't the best, as others have pointed out); good range of color combinations available, good brightness control etc. The biggest disappointment is that while they are clearly 4 pin/12 volt ARGB strips the connectors used on both of these packages are male and not interleaved ie they have contacts . sticking out…

These gauges are working as expected. They are quite light. I have 2 strips in my case and I am happy with how they look. I haven't tried cutting any of the strips so I can't comment on that. I don't use glue. The magnets work well. I have a stripe on the side and a stripe on top and both hold up. Haven't used them for a long time but so far so good. I'm happy! Updates: I bought two of these; Version with 3 stripes and 4 stripes. I used both magnets and glue. I am happy with both. The magnets…

I bought this kit to install in my own gaming rig. In my specific case, the wiring was a bit tedious (NZXT S340 Elite). As mentioned the magnets in these LED strips are so weak that they are unusable which is very disappointing as this was one of the main reasons I bought them. Note that this case is made of steel, so decent magnets won't stick. I prepared the surface and tested the glue to see if it held. On the plus side, they are recognized via the Asus Aura software and controlled with…