💡 Rig Rite 1050 24V Marine Circuit Breaker with Manual Reset - 50 Amp: Ultimate Protection for Your Marine Electronics Review

Installed directly on battery as indicated. Everything needed for the installation has arrived. I haven't tried it other than a test run.

I use it with my 50# pull trolling motor and it's been great so far. never worked I only use fresh water and the electronics are stored in my garage so I can't confirm long term corrosion protection at the moment but so far so good.

Small compact circuit breaker. The copper tab simply connects directly to the + terminal of the battery. The ring terminal that comes with the kit needs to be crimped onto the + wire going to the trolling motor. The largest size of this type of circuit breaker is 50 amps. I want the same circuit breaker to run at 60 amps.

I need a circuit breaker to protect my 12 volt trolling motor and associated wiring. Not only does this switch offer that protection, but it also has a reset button so it can be used over and over again. It fits perfectly on the positive side of my battery and associated power line that goes to the remote front location for my twistlock receiver. The trolling motor stalls during use.

I use them for boat engines. The spade connector on the battery side of the switch greatly simplifies battery connection and is corrosion resistant. The red ring connector is for the 8ga cable I usually use; but the other connector can be easily replaced (requires #10 screw hole). These circuit breakers have a manual reset button on the end, which I find to be safer and more reliable than the "auto-reset" type. (Note that the "auto-reset" type circuit breaker will continue to reset in the event