RION TECH 4 Pack Rubber Case Feet with Screws Screwdriver Kit Set for Apple MacBook Pro A1278 A1286 A1297 13 15 17 - Non-Retina Display Compatible Review

Case screws are perfect, screwdriver feels good. The case legs are great, but here are my recommendations: 1. Remove the included adhesive. It's as bad as double-sided tape.2. Use some type of glue like gorilla glue or feather glue (like the arrows I used) and clamp each body leg in place for 5 minutes.3. Remove excess glue after 5 min.4. Use fine sandpaper and sand the legs a bit to make them less slippery as my MacBook Pro would slide all over the table when I pushed it like it was walking on

is a good deal for the money as it comes with a good quality screwdriver and an extra set of case screws. The legs themselves are a one-piece version as opposed to the two-piece original factory units. fits perfectly. However, they are made of a harder, plastic-like material than standard feet. They don't stick like rubber originals and your MacBook can slip. and the glue is weak. I would recommend using some sort of super glue to stick them to and making sure the surface is completely clean of

I bought these this week while fixing a colleague's computer. He had a 2012 MacBook and was pretty rough on it. I replaced its hard drive and when I turned the computer over, it didn't have little feet on the laptop case! Crazy! One thing I didn't know was that without these feet there would only be small holes in the bottom of your laptop. When I opened up his computer to do the work, there was literally a wilted, dead LEAF in his computer! So these little guys have done their job, but I feel…