
Case screws are perfect, screwdriver feels good. The case legs are great, but here are my recommendations: 1. Remove the included adhesive. It's as bad as double-sided tape.2. Use some type of glue like gorilla glue or feather glue (like the arrows I used) and clamp each body leg in place for 5 minutes.3. Remove excess glue after 5 min.4. Use fine sandpaper and sand the legs a bit to make them less slippery as my MacBook Pro would slide all over the table when I pushed it like it was walking on ice. Or just move it around the wooden table for a while

MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review

🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review

uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review

M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review

🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review

Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack
9 Review

ZOTAC ZBOX-CI325NANO-U Series Nano Fan-Less Mini PC Intel N3160 Quad-Core CPU Silent Performance Barebone System SSD & RAM Not Included, No OS
12 Review

CZH-LABS Electronics-Salon Prototype Shield Kit for 🛠️ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review