⚓️ Set of 4 Round Anchor Point Tie Down Kit with Bolt On Fitting & Quick Release Tie Down Anchor Review

I am very satisfied with this device. This allows you to quickly and easily attach everything to the holding position. It is very durable when properly installed. I use it to hang a curtain on my converted van.

These are amazing items. I was looking for an unobtrusive mount for my bike and chocks, locks, weights etc. were just taking up too much valuable real estate in my trailer. I pocket two of these and tie them to the steps and that's it. The wheel holds up perfectly!

That's a great idea. We live on the RI coast which is prone to hurricane/wind damage. I bought them as a means of transportation to tie our stuff down on our outside decks. I haven't had a chance to use them but I think they will do the job. One observation: I received them with a black finish that goes pretty well with our house color. They have been in the sun for about a month and the black finish is now bronze. Use the best coating as suggested by the manufacturer.

So far they work great. As others have pointed out, the screws that come with the kit aren't long enough to go through the bottom of the trailer, so you'll probably have to go to a hardware store before installing them. I found the right diameter and length screws and they fit perfectly. However, I am a bit concerned about the tensile strength of the replacement bolts and how that affects load capacity. I would give five if it wasn't for that. The rest is nicely designed and does what it's…

The description mentions a ring diameter which I confused with the base diameter. I bought them to fit between the ribs of a truck bed. My ground clearance is 1- 1/2". They don't work for my intended application. I also noticed that there is a lot of play when the ring snaps onto the base. I assumed it would fit snugly and not be able to move from side to side on the base. This is the first such set I've gotten my hands on, so maybe my assumption was wrong. I'll probably hold onto them and…

This is an affordable and well-made way to add anchor points just about anywhere. Note that anodized aluminum components exposed to the sun take on a bronzed color from black as shown in my image above. For the rest I have no complaints. The hardware is of good quality, the nuts have nylon inserts so no lock washer is needed. The base plates spread the load over a larger area than using washers alone, and the screws are long enough to be placed on thicker materials. I've used them on the floor…

I bought these brackets to replace the cheap ones originally installed on my motorcycle trailer, one of which failed causing my HD to fall off😥. My trailer had 4 anchors, 1 on each corner. I am planning to move 2 anchors to the middle of the bike and trailer. I will do this because all ratchet straps should pull the bike into the wheel chock in the same direction. Now, if the strap or anchor fails, the bike stays in place because the remaining straps pull the bike 🏍 in the same direction at…