🔧 Rugged Ridge Roll Bar Cover Kit 13612.15 for Jeep Wrangler TJ 97-02 | Durable Black Full Set Review

The plastic on the inside of the roll bars on the driver and passenger side cracked during installation. Good, but I won't buy it again in the future.

All products with a zipper are easy to put on Two pieces that are designed to be put on are not so easy to put on because they are tight and the foam rubber sticks. Even after applying the lubricant, the foam is still broken up on the inside and looks ugly.

complete chinese bullshit. Don't waste money. I definitely got what I paid for and learned my lesson. The fit, finish and quality are terrible in my opinion. They fell apart when I installed them and the foam peeled off. I ordered a set bestop three times more expensive. After receiving and installing I will write a review.

The product is poorly made. The inner foam is not glued over the entire length, so when installing the pads on the front part of the carcass, the foam swelled and broke, making installation impossible. Bad cheap design. As previously mentioned, the front instrument panel pads do not zip or Velcro attach, so the windshield had to be lowered to attach them. Much more work than expected.

Very poor quality overall. Additionally, for front roll bar covers that mount to the windshield, you must detach the roll bars from the windshield and rear roll bars, and then wiggle the roll bar covers. It would be no problem. If only the foam pad was solid! I was only able to mount the pad a quarter of the way to the roll bar before it started to clump up, preventing me from fully installing the roll bar cover without removing the pad itself! Do yourself a favor and avoid this product.

Firstly I have a 2002 Jeep Wrangler TJ and there are some major issues with this cover for this model year. Firstly, the product description does not contain any information about the model the product is for, so I relied on Revain to tell me if this product fits my model and year. First edition. The arch back cover sticks out too far (OE stops where the soundbar mount starts) and I had to cut out the foam spacer (CHEAP!) and pin the cover so that it stops on top of the soundbar mount. The fix…